B3896 BMW Fault Code

Description:

The Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke).

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

B3896 Code Symptoms :

The scent may B3896 signal oil or coolant leaking from their normally closed-loop systems, or it may indicate dangerous exhaust gases invading your car's interior. Car and truck exhaust contains toxic gases such B3896, so if the inside of your car as if you were standing behind your car, get out and get it fixed.
Fight the urge to take a little nap first. So sleepy. That's the carbon monoxide talking, friends. At least open a window on your way to the shop.

Diagnosis And Repairing B3896

B3896 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix B3896 code ?

• Exhaust gas leaks
• EVAP system hose leaking
• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Variable Camshaft Timing (VCT) position circuit is open or shorted

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.